Mosquito® 12V 50W heater

Cartridge length: 22 mm;
Cartridge diameter: sized to fit into a 6mm H7 tolerance hole;
heater is 12cm in length and has Molex Micro-Fit male connector;
Extension cable is 1m in length;
Molex Micro-Fit female connector on one end;
Ferrules connector on the other end.
 
For Engineering-grade Plastics
Like upgrading the engine in your car, suddenly an unsuspecting machine can compete with the top of the line. The 50W Heater Cartridge takes your 3D printer and opens a whole new world of engineering-grade plastics that other off-the-shelf desktop printers can’t come close to.* Things like Nylon, Ultem, PEEK, and other plastics you always wanted to use for molds, medical devices, end use parts, or automotive components. They are now well within your reach.
 
Easy To Setup
Take the raw power of your 3D printer to the next level with a simple plug and play modification. Designed for effortless use, implementation, and reliability. We use 1 meter leads with Ferrules connectors that make it easy to reach the control board of even the largest printer. And with genuine Molex™ Micro-Fit 3.0 connectors, it’s easy to connect and disconnect without breaking any wires.
Do you want to see your unsuspecting printer churn out engineering-grade plastics without breaking a sweat?
 
*Some 3D desktop printers are capped at a certain temperature for safety reasons, and the manufacturer won’t lift it. Check with your printer model to see if it allows you to print at your desired temperature.