Bondtech HeatLink 300°C Thermistor

Plug & Play Thermistor
1.5m leads with blue sleeves and Molex micro-fit 3.0 female connector;
Ø 3mm 15mm long Stainless Steel crimped cartridge with laser engraved Bondtech logo;
SeMitec 104NT-4 temperature sensor;
Packed in plastic bag.
 
You must select ONE optional HeatLink Interface Cable below…… to connect this heater to your printer.Check compatibility table at bottom of this page.
 
Update your firmware
Before buying this thermistor to use it with the DDX extruder check if we have a firmware update to support it here: Firmware Updates For Creality Using DDX
Bondtech HeatLink 300°C Thermistor
 
Have it your way!This 300C thermistor based on the SeMitec 104NT-4-R025H42G temperature sensor and uses a Molex micro-fit 3.0 female connector to enable extending it with one of the HeatLink interface cables and connect to your printer without hassle.
Do not use this thermistor at nozzle temperatures above 300°C.
Use the following code to customize your Marlin2.0 to use this thermistor:#define TEMP_SENSOR_0 5